Personalized Gurmukhi and English Name Decal
Add a personal touch to your car with our premium permanent vinyl decals. Designed with a clean, modern finish, perfect for adding something special to your vehicle and other suitable smooth surfaces.
Please note: This decal is not reusable once applied. Its durability depends on the surface, application and environmental conditions.
Decal Specification
- Approximately 3 inches in height, width depends on name
- Permanent adhesive vinyl
- Smooth matte finish
- Water resistant
- Suitable for indoor and outdoor use
How To Apply The Decal
1. Clean the surface - Make sure the surface is smooth, clean and completely dry before applying your decal.
2. Position the decal - Place the decal where you want it and check that it’s straight and properly aligned.
3. Peel the backing - Carefully peel back about 1/4 of the white backing from one side of the decal. Make sure the decal stays attached to the transparent tape.
4. Apply the decal - Press the exposed section onto the surface. Use a credit card or squeegee to firmly smooth it down.
5. Remove remaining backing - Slowly peel away the rest of the white backing while gradually pressing the decal onto the surface.
6. Smooth out - Run your card or squeegee over the entire decal several times to help it adhere securely and minimize air bubbles.
7. Remove the transparent tape - Slowly peel the transparent tape back at a low angle. If any part of the decal lifts with the tape, lay the tape back down, and press firmly over the area, and try again.
Tips!
- Avoid touching the adhesive side of the decal
- Make sure the surface is clean and smooth. Results may vary on textured, curved, waxed or freshly painted surfaces
- Give the adhesive time to bond before exposing the decal to moisture or washing your vehicle
- Avoid applying the decal in extreme temperatures
- To get rid of small air bubbles, gently press them toward the nearest edge using a credit card or squeegee. Avoid pulling or stretching the vinyl. Do not poke holes, or use sharp objects to remove bubbles, as this may damage the design or the surface underneath